Hans Grohe Metris M71 220 2jet sBox 73800 Series Instructions For Use/assembly Instructions

4EnglishAssembly (see page 33)Safety NotesGloves should be worn during installation to prevent crushing and cuttinginjuries.The hot and cold supplies must be of equal pressures.Installation Instructions• Prior to installation, inspect the product for transport damages. After it has beeninstalled, no transport or surface damage will be honoured.• The pipes and the fixture must be installed, flushed and tested as per theapplicable standards.• The plumbing codes applicable in the respective countries must be observed.• During initial start-up and after servicing, air in the fittings can cause noise. Afterswitching the jet on and off about 15 times, the noise will stop.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 60°CThermal disinfection: 70°C / 4 minThe product is exclusively designed for drinking water!Symbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 37)To adjust the hot water limiter. Using a hot water limiter in combination with acontinuous flow water heater is not recommended.Maintenance (see page 37)The check valves must be checked regularly according to EN 806-5 in accordancewith national or regional regulations (at least once a year).Dimensions (see page 39)Flow diagram (see page 39)Spare parts (see page 40)XXX = Colors000 = Chrome Plated800 = Stainless Steel OpticSpecial accessories (order as an extra)• extension #43333000 (see page 36 / 40)• Adapter (G⅜ / G½) (see page 40)Cleaning (see page 38)Operation (see page 37)• Hansgrohe recommends not to use as drinking water the first half liter of waterdrawn in the morning or after a prolonged period of non-use.• Minor leaking may occur briefly at the spout when opening the fitting via thelever.Test certificate (see page 38)Fault Cause RemedyInsufficient water - Aerator calcified, dirty - Clean aerator, replace as necessaryMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective - Exchange cartridgeWater escaping at the threaded base - connection hoses not completely screwed into basicbody- Tighten connection hoses by hand- O-ring at the connection hose defective. - Exchange O-ringHot water temperature too low - Hot water limiter incorrectly set - Set hot water limiter