Hans Grohe Metris Select 320 1jet Instructions For Use/assembly Instructions

Also see for Metris Select 320 1jet Series: Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use

3EnglishAssembly (see page 4)Safety NotesGloves should be worn during installation to prevent crushing and cuttinginjuries.The hot and cold supplies must be of equal pressures.Installation Instructions• Prior to installation, inspect the product for transport damages. After it has beeninstalled, no transport or surface damage will be honoured.• The pipes and the fixture must be installed, flushed and tested as per theapplicable standards.• The plumbing codes applicable in the respective countries must be observed.• During initial start-up and after servicing, air in the fittings can cause noise. Afterswitching the jet on and off about 15 times, the noise will stop.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 60°CThermal disinfection: 70°C / 4 min• The product is exclusively designed for drinking water!• Safety against backflowSymbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 6)To adjust the hot water limiter. Using a hot water limiter in combination with acontinuous flow water heater is not recommended.Maintenance (see page 9)The check valves must be checked regularly according to EN 806-5 in accord-ance with national or regional regulations (at least once a year).Dimensions (see page 8)Flow diagram (see page 8)Spare parts (see page 10)Cleaning (see page 7)Operation (see page 6)• Hansgrohe recommends not to use as drinking water the first half liter of waterdrawn in the morning or after a prolonged period of non-use.• Minor leaking may occur briefly at the spout when opening the fitting via thelever.• Use the lever to open the tap and set the desired temperature. The water flowcan be paused by pressing the Select button on the face side of the spout.When the tap is not used for a longer period of time, f.e. when retiring at nightor leaving the house, it must be closed completely by means of the lever.Fault Cause RemedyNo water - No plunger (A) for the backflow preventer wasinstalled- Install plunger (A) (see page 32 / 36)Mixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective - Exchange cartridgeWater escaping in area of swivel spout - O-ring defective - Exchange O-ringWater escaping at the threaded base - connection hoses not completely screwed into basicbody- Tighten connection hoses by hand- O-ring at the connection hose defective. - Exchange O-ringHot water temperature too low - Hot water limiter incorrectly set - Set hot water limiterLow flow with Select valve after valve replacement - Improper Select valve installed - Replace Select valve (#98463000)Select button stiff - Select button soiled - Clean Select button and grease 23x1,5 O-ring(see page 10)