Hans Grohe Metris Series Instructions For Use/assembly Instructions

Also see for Metris 31280000: Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use Instructions for use/assembly instructions Assembly instructions

Contents

installation instructions

Hans Grohe Metris Series Instructions For Use/assembly Instructions Manual pdf 4 page image

6 Safety Notes6 Gloves should be worn during installation to preventcrushing and cutting injuries.6 The shower system may only be used for bathing,hygienic and body cleansing purposes.6 The hot and cold supplies must be of equalpressures.Installation Instructions• The fitting must be installed, flushed and tested afterthe valid norms.• If the instantaneous water heater causes problems orif you wish to increase the water flow, the EcoSmart®(flow limiter) located behind the aerator can beremoved.Technical DataThis mixer series-produced with EcoSmart®(flow limiter)Operating pressure: max. 1 MPaRecommended operating pressure: 0,1 – 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CHansgrohe mixers can be used together withhydraulically and thermically controlled continuous flowheaters if the flow pressure is at least 0,15 MPa.EnglishCleaning (see enclosed brochure)Operation (see page 38)Spare parts (see page 36)Assembly see page 31Dimensions (see page 34)Do not use silicone containing acetic acid!Special accessoriesspecial tool (58085000) order as an extraInstallation kit order as an extraTo adjust the hot water limiter on single levermixers, please see page 33. No adjustmentis necessary when using a continuous flowwater heater.Symbol descriptionFlow diagram(see page 34) with EcoSmart® without EcoSmart®Test certificate (see page 38)4