Hans Grohe Rebris S 72440 Series Instructions For Use And Assembly Instructions

Also see for Rebris E 72450: Instructions for use/assembly instructions

4EnglishSafety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The product may only be used for bathing, hygienicand body cleaning purposes.The hot and cold supplies must be of equalpressures.Installation Instructions• Prior to installation, inspect the product for transportdamages. After it has been installed, no transport orsurface damage will be honoured.• The pipes and the fixture must be installed, flushedand tested as per the applicable standards.• The plumbing codes applicable in the respectivecountries must be observed.• The diverter (type HC) installed in the bath mixer isdesigned as an anti-retraction device. For this reason,the lower edge of the diverter must be at least25 mm above the highest possible dirty water level.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 60°CThermal disinfection: 70°C / 4 min• Safety against backflow• The product is exclusively designed for drinkingwater!Symbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 38)To adjust the hot water limiter. Using a hot water limiterin combination with a continuous flow water heater isnot recommended.Maintenance (see page 42)The check valves must be checked regularly accordingto EN 806-5 in accordance with national or regionalregulations (at least once a year).Dimensions (see page 40)Flow diagram (see page 42)Spare parts (see page 43)XXX = Colors000 = Chrome Plated670 = Matt BlackCleaning (see page 39)Operation (see page 35)Test certificate (see page 44)Assembly (see page 36)Fault Cause RemedyInsufficient water - check valve hasn't moved back - Exchange check valves- Shower filter seal dirty - Clean filter seal between showerand hoseMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defectiveThermostat hasnot been adjusted- Exchange cartridgeHot water temperature too low - Hot water limiter incorrectly set - Set hot water limiterInstantaneous heater didn’t work - Flow limiter in handshower isn’tremoved- Remove flow limiter- Shower filter seal dirty - Clean filter seal between showerand hose- check valve hasn't moved back - Exchange check valves