Hans Grohe Talis S 32420000 Manual

Also see for Talis S 32420000: Assembly instructions Instructions for use Installation instructions

Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The shower system may only be used for bathing, hygienicand body cleansing purposes.Children as well as adults with physical, mental and/orsensoric impairments must not use this shower systemwithout proper supervision. Persons under the influenceof alcohol or drugs are prohibited from using this showersystem.The hot and cold supplies must be of equal pressures.Assembly (see page 32)Important! The fitting must be installed, flushed andtested after the valid norms.Important! Do not use silicone containing acetic acid!OperationThe mixer is activated by lifting the lever handle.Turning to the left = warmer water,turning to the right = cooler water.Shower mixer: The flow is changed from bath to showerfunction by pulling the knob at the upper side of thespout. After shutting off the water flow, the mixer returnsautomatically to the bath function.Technical Data (see page 31)Operating pressure: max. 1 MPaRecommended operating pressure: 0,1 – 0,5MPaTest pressure: 1,6MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CCentre distance: 150 mm ±12mmConnections: cold right - hot leftRate of flow by 0,3 MPa: 18 l/minanti-pollution functionHansgrohe single lever mixers can be used together withhydraulically and thermically controlled continuous flowheaters if the flow pressure is at least 0,15 MPa.To adjust the hot water limiter on single lever mixers, pleasesee page 35.No adjustment is necessary when using a continuous flowwater heater.Important! The non return valves must be checkedregularly according to DIN EN 1717 in accordance withnational or regional regulations (at least once a year).Spare parts (see page 34)Cleaning (see page 36)EnglishFault Cause RemedyInsufficient water - Shower filter seal dirty - Clean filter seal between showerand hose- Non return valve hasn't movedback- Exchange non return valves- Aerator calcified, dirty - Clean aerator, replace asnecessaryMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective - Exchange cartridgeHot water temperature too low - Hot water limiter incorrectly set - Set hot water limiterInstantaneous heater didn’t work - Flow limiter in handshower isn’tremoved- Remove flow limiter- Filters are dirty - Clean the filter / exchange filter- Non return valve hasn't movedback- Exchange non return valves