Hans Grohe Tecturis S 73440 Series Instructions For Use/assembly Instructions

Also see for Tecturis E 73445 Series: Instructions for use

Fault Cause RemedyInsufficient water - Aerator calcified, dirty - Clean aerator, replace as necessary- Shower filter seal dirty - Clean filter seal between shower and hoseMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective - Exchange cartridgeSpout temperature does not correspond with tempera-ture set- Hot and cold supplies are reversed - Install function block turned through 180° (see page38 )Instantaneous heater didn’t work - Shower filter seal dirty - Clean filter seal between shower and hose- Flow limiter in handshower isn’t removed - Remove flow limiter4EnglishAssembly (see page 33)Safety NotesGloves should be worn during installation to prevent crushing and cuttinginjuries.The product may only be used for bathing, hygienic and body cleaningpurposes.Children as well as adults with physical, mental and/or sensoric impairmentsmust not use this product without proper supervision. Persons under the influenceof alcohol or drugs are prohibited from using this product.Do not allow the streams of the shower touch sensitive body parts (such as youreyes). An adequate distance must be kept between the shower and you.The product may not be used as a holding handle. A separate handle must beinstalled.The hot and cold supplies must be of equal pressures.Installation Instructions• Prior to installation, inspect the product for transport damages. After it has beeninstalled, no transport or surface damage will be honoured.• The pipes and the fixture must be installed, flushed and tested as per theapplicable standards.• The plumbing codes applicable in the respective countries must be observed.• The mesh washer must be insert to protect the shower against incoming dirt bypipework. Incoming dirt leads to defects or/and can damage parts of theshower; such caused faults voids all liability and guarantee claims.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 60°CThermal disinfection: 70°C / 4 minThe product is exclusively designed for drinking water!Symbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 34)To adjust the hot water limiter. Using a hot water limiter in combination with acontinuous flow water heater is not recommended.Hot and cold supplies are reversed (see page 34)Dimensions (see page 38)Flow diagram (see page 38) Hand shower Bath SpoutSpare parts (see page 40)XXX = Colors000 = Chrome Plated140 = Brushed Bronze670 = Matt Black700 = Matt WhiteSpecial accessories (order as an extra)extension 60 mm #93882000 (see page 40)Cleaning (see page 36)Operation (see page 37)Test certificate (see page 44)