(5)3. Level out any unevenness on the groundusing the two front screw feet (5).– Close the doors.– Tilt the appliance backwards slightly andscrew/unscrew the screw feet (5).– Stand the appliance back up again andcheck the alignment with a spirit level.Repeat the process until the applianceis standing up vertically. The applianceshould not move when opening thedoors.Basic cleaningIn order to remove the odour which is presentin all new appliances, wipe the interior withdiluted vinegar prior to first use. Then wipe itout with clean water and dry all of the partsoff afterwards.Commissioning the applianceCAUTIONFire hazard!Improper handling of the appliancecan lead to fire and property damage.■ Only connect the appliance to aproperly installed and earthed elec-tric socket. Do not connect to a mul-ti-socket extension cable or a mul-ti-socket plug.NOTICERisk of damage!If the appliance has been transportedhorizontally, lubricant from the com-pressor may make its way into the cool-ing circuit.■ Allow the appliance to stand uprightfor approx. 2 hours after transportand before connecting. This allowsthe lubricant enough time to flowback into the compressor.• Insert the mains plug into an easily acces-sible and properly installed socket (220-240 V~ / 50 Hz).The fridge light is automatically switchedon and off when the upper door is open orclosed.You will find all important informationabout operation from page GB-12.Start-up Page GB-25