6 7INITIAL INSTALLATIONIMPORTANT: If angle mounting, make sure open end ofmounting bracket (A) is installed facing the ceiling.Depending on the mounting method (A or B)chosen in Step 1, either proceed to page 7 for“DOWNROD-STYLE MOUNTING” or proceed topage 8 for “CLOSEMOUNT-STYLE MOUNTING.”DOWNROD-STYLE MOUNTING1. Determine mounting method.A-Downrod Mount (standard or angled ceiling)B-Closemount (standard ceiling only)IMPORTANT: If angle mounting, check to makesure the ceiling angle is not steeper than 20°.3. Install mounting bracket (A) to outlet box (not included)by sliding mounting bracket (A) over the two outlet boxscrews (not included). Securely tighten two outlet boxscrews.2. Remove two non-slotted screws on canopy (B) andsave, then loosen the two slotted screws. Removemounting bracket (A) from canopy (B).1 122. Insert downrod (D) through canopy (B) and canopycover (C). Thread wires from motor housingassembly (G) through downrod (D).1. Remove preassembled pin and clip fromdownrod (E). Save for later use.2AOutlet boxClipPinEC DBLoosen but donot removeRemoveand saveAB33. Loosen preassembled set screws from the yoke onmotor housing assembly (G). Slip downrod (D) into yoke,aligning holes on both parts. Insert previously removedpin through holes on yoke and downrod (D), then insertpreviously removed clip into the pin until it snaps intoplace. Tighten set screws.Set screwDGClipPin3Lowes.com/harborbreezeLowes.com/harborbreezeAB