Page 4 For technical questions, please call 1-888-866-5797. Item 62858AssemblyRead the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of thismanual including all text under subheadings therein before set up or use of this product.TO PREVENT SERIOUS INJURY:Do not leave this product partially assembled. Assemble this product completely at one time.Note: For additional information regarding the parts listed in the following pages,refer to Parts List and Diagram on page 10.Note: Much of this product’s assembly is done using slip fit construction. Make sure all parts seat completelyand securely. A rubber mallet (sold separately) can be used to gently tap parts in place to ensure a tight fit.Figure 1: Roof Assembly - 1522 4 2333 222 52426624552421. Assemble one half of the roof using 11x Swaged Tubes (2), 3x Rafter Tubes (3),4x Straight Cross Tubes (4), 4x 3-Way Connectors (5), and 2x 4-Way Connectors (6).Align the 3- and 4-Way Connectors so that the free ends are all on thesame side of the assembly, as shown in Figure 1.Figure 2: Roof Assembly - 25 2 4 2 6 2 4 2 55653332 222. Connect a Swaged Tube (2) to each 3- and 4-Way Connector (5,6) at the top of the roof.Connect a Rafter Tube (3) to the end of each Swaged Tube (2).Connect 4x Swaged Tubes (2), 2x Straight Cross Tubes (4), 2x 3-Way Connectors (5), and1x 4-Way Connector (6) together, then attach that assembly to the ends of the Rafter Tubes (3).SAFETY MAINTENANCEASSEMBLY