Page 6For technical questions, please call 1-800-444-3353.SKU 67437SpECIFICAtIOnSWeight Capacity 250 lb.Wheelchair Width 24”Weight 40 lb.Wheels Solid Rubber Tires and360° Swivel CastersSeat Width 20-1/4” x 16-5/8” DeepunpACKIngWhen unpacking, make sure itemis intact and undamaged. If parts aremissing or broken, call Harbor FreightTools at 1-800-444-3353.ASSEmBLY/OpERAtIOnSInStRuCtIOnSRead the EntIRE ImpORtAntSAFEtY InFORmAtIOnsection at the beginning of thismanual including all text undersubheadings therein before setup or use of this product.For additional informationregarding the parts listed in thefollowing pages, refer to AssemblyDiagram near the end of manual.unfolding/FoldingBefore unfolding Wheelchair, make1.sure Rear Wheels (3) are in thelocked position.Hold the Armrests (10) and pull them2.away from one another, unfolding theWheelchair.As Wheelchair unfolds, press down3.on Seat (6).Swivel Footplates (2) so they are4.horizontal.To fold the Wheelchair, lock the Rear5.Wheels and fold Footplates up.Pull up on the Seat and push6.Armrest closer together, folding theWheelchair.Installing Foot RestsSlide the Footplates (2) to the side1.(so that they are perpendicular to theWheelchair. See Figure 1, below.Install the end of each Detachable2.Footrest (1) onto the tab extendingfrom the Wheelchair Frame (9). SeeFigure 1, above.Swivel the Footrest towards the3.inside of the Wheel Chair until it locksinto place.Please note: When properly installed,4.Footplate will be on the inside of theWheel Chair when locked into place.To remove, push the Control Handle5.out and lift the Foot Rest off theWheelchair. See Figure 1, above.Footplate (2)Foot Rest (1)ControlHandleTabFigure 1