Harbor Freight Tools 96618 Set Up And Instructions Manual
    | |
Page 296618 / 96619 For technical questions, please call 1-800-444-3353.SPECIFIC SAFETy rulESWArNING! read all instructions before setup and use.Please note: all the warnings listed below apply to BOTH the 96618 2-StepFoot Switch and 96619 Foot Switch.Failure to follow all instructions listed below may result in electric shockand/or serious injury.Do not use Foot Switch near water; switch mechanism is not insulated.Inspect before use; do not use if parts are loose or damaged.Do not use with any tool rated higher than 120 VAC, 15A.Use only with a grounded 120V outlet.Wear ANSI-approved safety goggles during use.Before leaving, turn off the main power switch of the tool used with Foot Switch.Use only on flat, level surface able to support weight of Foot Switch and theoperator.Keep away from children. Do not let children play with Foot Switch.When finished, always unplug from tool and store in a secure location.If mounting the Foot Switch to the floor, verify that mounting surface has nohidden utility lines before drilling or driving screws.Maintain proper balance during use to prevent foot from sliding off Switch.The warnings, precautions, and instructions discussed in this instruction manualcannot cover all possible conditions and situations that may occur. It must beunderstood by the operator that common sense and caution are factors whichcannot be built into this product, but must be supplied by the operator.SAVE THESE INSTruCTIONS.uNPACkINGWhen unpacking, check to make sure that the item is intact and undamaged. Ifany parts are missing or broken, please call Harbor Freight Tools at the number shownon the cover of this manual as soon as possible.1.2.3.4.5.6.7.8.9.10.11.12. |
manualsdatabase
Your AI-powered manual search engine