Harbor Freight Tools 96755 Set Up And Operating Instructions Manual
        | |
Page 7SKU 96755 For technical questions, please call 1-800-444-3353.Maintenance and serVicingcleaning and removing the staple channelPush the Retaining Clip at the front of the Staple Gun forward to release theStaple Channel. Pull the two tabs (located midpoint on the bottom of the StapleGun) toward the back of the Staple Gun.The Staple Channel is now free of the Staple Gun and can be cleared of anyjammed fasteners and debris.cleaning, maintenance, and lubricationBeFOre eacH use, inspect the general condition of this product. Check forloose screws, cracked or broken parts and any other condition that may affect itssafe operation.Remove dirt and debris from the Staple Gun using a clean, soft cloth. Do notuse flammable corrosive or abrasive solvents to clean the Staple Gun.trOuBlesHOOtingproblem possible causes probable solutionsStaple Gun does not staple Staples not loadedcorrectly.Magazine Unit not fullyand properly inserted intoStaple Gun.Lever not pulledcompletely up and thenfully pressed down.1.2.3.Verify that staples are loaded intothe Magazine Unit flat and withprongs facing upward.Check that Magazine Unit is fullyinserted.1.2.Stapler jams during operation Staples jammed inchannel.1. Pull out the Staple Channel.Remove jammed fastenersfrom the channel. You mayneed to use long-nosed pli-ers (not included).Make certain that you areusing correct size fasteners.Replace Staple Channel.1.2.3.4.1.2.1.2. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine