Hargrove Sierra Installation And Operation Manual

Contents

Hargrove Sierra Installation And Operation Manual Manual pdf 2 page image

2IMPORTANT INFORMATIONThe Firepit must be used for outdoor spaces only. For the purpose of this requirement,an appliance is considered to be outdoors in an open environment or with walls andceiling no more inclusive than:1. With walls on all sides, but not with a overhead cover.2. Within a partial enclosure which includes a seven foot overhead cover and nomore than two side walls. These side walls may be parallel, as in a breezeway,or at right angles to each other.3. Within a partial enclosure which includes a seven foot overhead cover andthree side walls, as long as 30 percent or more of the horizontal periphery of theenclosure is permanently open.*THIS APPLIANCE MAY NOT BE USED INSIDE A BUILDING, GARAGE OR ANY OTHERENCLOSED AREA!1. Do not use a natural gas set for a propane set or a propane set for a natural gas set.2. There are many different local codes for outdoor fireplaces. The installation and the provision for combustion mustconform with local codes and, or in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1 – (mostcurrent revision.)3. The firepit must be installed by personnel qualified for installing gas appliances.4. Solid fuels are not to be burned where the firepit is installed.5. The firepit should be examined prior to use and inspected by a qualified agency. The burner should be cleaned annuallyby a qualified agency.6. To clean the burner, shut off and disconnect the gas supply, use a pipe cleaner to clean out burner ports and vacuum theinside of the burner by removing the orifice/air mixer fitting from the inlet of the burner. After the burner is cleaned, attachthe orifice/air mixer fitting onto the inlet of the burner and reconnect the gas supply. Light according to the “LightingInstructions”.7. After burning the log set, they become fragile and should be handled carefully. Knocking or rubbing logs can cause thelogs to crumble and is not covered under the warranty.8. To clean the logs, use a soft dry paintbrush for periodic dusting of the gas fire logs. Special care must be taken to cleanthe logs because rubbing will remove soot but will also remove the color.9. If the firepit has a cover, allow the firepit to completely cool prior to covering.10. The top of the firepit must be fully open and clear of any obstruction prior to igniting the burner system. All covers, capsand lids must be removed before the burner system is in operation.14. A manual gas valve and 11.0” W.C. pressure regulator must be installed prior to the use of the propane cylinder.