Harman Kardon AVR 360 Function Manual

Also see for AVR 360: Owner's manual Owner's manual

Contents

Harman Kardon AVR 360 Function Manual Manual pdf 13 page image

13ENGLISHADVANCED FuNCTIONSTo program, or “record” an activity, follow these steps:To enter Program mode, simultaneously press and hold the Activity1.Button and the Alphanumeric Key or AVR Power On or Off Button to whichthe activity will be assigned.Press the Source Selector (or Setup Button) for each device before you2.enter individual commands. This step counts as one of the 19 commandsallowed for each activity.For Power On, press the AVR or Device Power On Button.3.Press the AVR or Device Power Off Button for Power Off.4.Press the Activity Button to end the programming process, and the last5.Source Selector (or the Setup Button) will flash three times.It isn’t possible to “edit” a command within an activity. To erase the activity:Press and hold the Activity Button and the Alphanumeric Key or AVR1.Power On or Off Button until the Source Selector or Setup Button lights.Press the Activity Button to erase the activity.2.To execute an activity, press the Activity Button, then press the AlphanumericKey (or the AVR Power On or Off Button) for the Activity.Learning (aVr 460 only)If you have programmed a product’s codes into the remote and find that somefunctions are missing, the AVR 460 remote may “learn” individual codes fromthe product’s original remote. See page 24 in the Basic Manual.resetting the remoteTo reset the remote to its factory defaults, simultaneously press and holdthe TV Source Selector and the “0” Alphanumeric Key. When the TV Buttonrelights, enter the code “333”. When the TV Button goes out, and all of theSource Selectors flash, the remote control will be reset.proceSSor reSetIf the unit behaves erratically after a power surge, first turn off the MainPower Switch and unplug the AC power cord for at least 3 minutes. Plug thecord back in and turn the receiver on. If this doesn’t help, reset the AVR.NOTE: A system reset erases all user configurations, including videoresolution, speaker and level settings, and tuner presets. After a reset,reenter all of these settings from your notes in the appendix worksheets.To reset the AVR 460/AVR 360, place it in Standby mode (press the front-panel Standby/On Switch so that the Power Indicator turns amber). Thenpress and hold the front-panel OK Button for at least 5 seconds until theRESET message appears.If the receiver does not function correctly ofter a processor reset, contact anauthorized Harman Kardon service center for assistance. Authorized servicecenters may be located by visiting the Web site at www.harmankardon.com.NOTE: After performing a system reset, wait at least 1 minute beforepressing any Source Selectors.memoryIf the AVR 460/AVR 360 is unplugged or experiences a power outage, it willretain user settings for up to four weeks.