FRONT-PANEL CONTROLS1 Standby/On Switch2 Surround Mode Group Selector3 Surround Mode Selector4 Tuning Selector5 Tuner Band Selector6 Preset Station Selector7 Input Source Selector8 Tuning Mode Selector9 Front-Panel Door) Volume Control! Input Indicators@ Speaker/Channel Input Indicators# Upper Display Line$ Lower Display Line% Surround Mode Indicators^ Remote Sensor WindowFRONT-PANEL CONTROLSFRONT-PANEL CONTROLS 55The following controls and indicators are available on the AVR 745’s front panel:The following controls and jacks are located behind the front-panel door. To open the door, place the edge of a finger on the left or right edge of the panel and gently swing thedoor down toward you.A Main Power SwitchB Headphone JackC Tone Mode ButtonD Speaker Selector ButtonE Channel Adjust SelectorF Digital Input SelectorG Delay Adjust SelectorH ‹/› ButtonsI Set ButtonJ EzSet/EQII Microphone JackK Optical 4 Digital InputL Input/Output Status IndicatorsM Coaxial 4 Digital JackN Video 4 Input/Output Jacks1 Standby/On Switch: When the Main PowerSwitch A is “ON,” press this button to turn on theAVR 745; press it again to turn the unit off. Note thatthe illumination surrounding the switch will turn bluewhen the unit is on, or in the Multiroom mode.2 Surround Mode Group Selector: Press this but-ton to select the top-level group of surround modes.Each press of the button will select one of the sur-round mode categories. Once the button is pressed sothat the name of the desired surround mode categoryappears in the on-screen display and in the LowerDisplay Line $, press the Surround ModeSelector 3 to cycle through the individual modesavailable. For example, press this button to select Dolbymodes, and then press the Surround Mode Selector3 to choose from the various mode options.3 Surround Mode Selector: Press this buttonto select from among the available surround modeoptions for the surround mode category selected.The specific modes will vary based on the number ofspeakers available, the surround mode category andwhether the input source is digital or analog. For exam-ple, press the Surround Mode Group Selector 2to select a category such as Dolby or Logic 7, andthen press this button to see the specific mode choicesthat are available. For more information on modeselection, see pages 40 – 42.NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product atwww.harmankardon.com.2 4 5 6 7 9!@#%3 8A B D E F G H HI J K LL NM)$^1CAVR 745XMFMAMUSBDMPTAPE8CH6CHDVDDIGITALPRO LOGIC IIxHEADPHONEVIRTUAL SPEAKER57CH. STEREOEQ 1 2 3DIRECTDSPSURR. OFFCDMIHDMIVID 34VID 12AVR745 harman/kardon7