Harman Kardon GO+PLAY Wireless Owner's Manual

Also see for Go+Play: User guide User guide User guide User guide Quick start guide

Contents

Harman Kardon GO+PLAY Wireless Owner's Manual Manual pdf 4 page image

4GO + PLAY WIRELESSHARMAN KARDON Bluetooth Pairing andTechnical SpecificationsListening to Audio from a Bluetooth-Capable Device1. Press the Harman Kardon Go + Play Wireless’s “Power” button. The Status LED will illuminate white.2. The Harman Kardon Go + Play Wireless unit will automatically enter the Bluetooth pairing mode.3. Perform a new device search on your Bluetooth-capable device.4. Select “GO+PLAY WIRELESS” on the device’s pairing list. If the device asks for a passcode,enter 0000.5. When pairing is successful the Harman Kardon Go + Play Wireless’s Status LED will changeto blue.6. Control playback from your Bluetooth-capable device.To pair with a different device, press and hold the Power button until the LED turns white, thenrepeat steps 3 – 5 above.Listening to Music from an Auxiliary Device1. Connect the auxiliary device’s output into the “Aux in” jack by using a stereo 3.5mm (1/8"auxiliary cable (not supplied).2. Press the “Power” button located on top of the Harman Kardon Go + Play Wireless systemto turn on the unit.3. Control music playback through the auxiliary device.4. Adjust volume using the Volume Up (“+”) and Volume Down (“–”) buttons located on top ofthe unit.Charging Your iPhone/iPod1. Use the cable that came with your iPad, iPhone or iPod to connect it to the rear USB portof the Go+Play Wireless. (The rubber landing area on top of your Go+Play Wireless is theperfect place for resting your iPhone or iPod while charging.)2. Make sure that the Harman Kardon Go + Play Wireless unit is connected to a live electricaloutlet. Note: The Harman Kardon Go + Play Wireless system will not charge other devices.3. The Harman Kardon Go + Play Wireless unit will not charge an iPhone/iPod device whilerunning on battery power.Technical SpecificationsModel: Harman Kardon Go + Play ™ WirelessOptional batteries for unit: 8 type D alkaline batteriesDrivers: Two Ridge and two Atlas transducersPower: Tweeters: 2 x 15 watts @ 1% THDWoofers: 2 x 30 watts @ 1% THDFrequency response: 40Hz – 20kHzInput sensitivity (Aux In): 250mVBluetooth transmitter frequency range: 2.4GHz – 2.4835GHzBluetooth transmitter power: ≤20dBm (EIRP)Bluetooth transmitter modulation: GFSK/ /4-DQPSK/8-DPSKDimensions: Length: 20" (500mm)Width: 9" (230mm)Height: 9-1/2" (240mm)Weight: 9.4 lb (4.3kg)Input impedance: >10k ohmsSignal-to-noise ratio: >85dBExternal power supply Input voltage: 100 – 240V ACOutput voltage: 18VDC @ 3.6APower consumption: 65W (maximum); 0.5W (standby mode)HARMAN International hereby declares that this equipment is in compliance with the essential requirementsand other relevant provisions of Directive 1999/5/EC, ErP 2009/125/EC Directive and RoHS 2011/65/EUDirective. The declaration of conformity may be consulted in the support section of our Web site, accessiblefrom www.harmankardon.com

/ 6

Related manuals for Harman Kardon Go+Play