Harman Kardon HKTS 5 Owner's Manual

Also see for HKTS 5: Service manual Specifications Owner's manual Owner's manual

Contents

Harman Kardon HKTS 5 Owner's Manual Manual pdf 5 page image

HKTS 55EnglishMounting Options3. Bring the speaker cable through the wall-bracket attachment plate, and mount theattachment plate on the wall in the desired location.Bring Speaker CableThrough Opening4. Thread the speaker cable through the arc-shaped opening on the top of the mountingbracket, not the screw hole.Cable toSpeakerCable fromWall PlateSide ViewOverhead ViewBring Speaker CableThrough Arc-ShapedOpening5. Attach the mounting bracket to the wall plate by inserting the tab at the top of theattachment plate into the slot on top of the bracket and snapping the bracket ontothe attachment plate.Insert Tab into Slotand Snap Bracketonto PlateFeed Cable ThroughMount and out ofOpening6. Fit the terminal cover onto the bracket as shown in the illustration below, thenconnect the speaker leads to the terminals on the underside of the speaker.Remember to observe the correct polarity.Terminal CoverMounting BracketSide ViewConnect Cable Leadsto Speaker Terminals7. Fit the terminal cover into the opening on the underside of the speaker so that it isflush against the speaker and covers the terminals. Insert the supplied long bracketbolt up through the bottom of the bracket and terminal cover, and screw it into thethreaded insert on the underside of the speaker. The bolt should be snug but not sotight as to prevent the speaker from pivoting on the bracket.Fit Terminal Coverinto Recess onSpeaker BottomAttach Speakerto Bracket UsingLong BoltYou can pivot the wall-mounted speaker from side to side; however, attempting to tilt itup or down will damage the bracket and possibly the wall, which would not be coveredby your warranty.Wall-Mounting the Center Speaker1. Determine the location for the speaker. If possible, position the speaker so that oneof the mounting screws (not included; use size #10) can be installed directly into awall stud. If that is not possible, use optional wall anchors that are rated to supportat least 25 lb (11.3kg) and are appropriate for the construction and materials of yourwall. The customer is responsible for the proper selection and use of mountinghardware, available through hardware stores, to wall-mount the speakerproperly and safely.2. Bring the speaker cable through the wall-bracket attachment plate as shown, andmount the attachment plate on the wall in the desired location.Use Mounting Hardware Appropriatefor Wall Construction and MaterialsBring Cable ThroughOpening3. Remove the rubber pads from the foot rests on the bottom of the center speakerand connect the speaker leads to the terminals on the underside of the speaker.Remember to observe the correct polarity.4. Use the supplied screws to attach the speaker to the wall-mount bracket. The screwsthread into the center foot-rest openings that were exposed when you removed therubber pads in the previous step.Use Supplied Screwsto Attach Speaker toBracketThread Screws intoCenter OpeningsConnectCableRemove Pads