HKTS 60BQ/23010+–+– +–+–+–LEFT LINE-LEVELOUTPUTSL R+ – + – + –+ –+ –+ –+ –RIGHTSURROUNDFRONT CENTRESpeaker ConnectionsFront left Speaker Cable(White Bands) Center Speaker Cable(green Bands)Surround Right Speaker Cable (gray Bands)ReceiverSubwooferSurround left SpeakerCable (Blue Bands)Front Right SpeakerCable (Red Bands)Set Input Mode Switchto “normal”Stereo Audio Cable (notsupplied, Red and White ends)Connecting the Subwoofer to a Receiver or Preamp/Processor withLine OutputsUse this installation method for receivers and preamp/processors that do not have adedicated subwoofer output but do have preamp-level (volume-controlled) line outputs.If the receiver or preamp/processor has a dedicated subwoofer output with low-passfiltering, see Connecting the Subwoofer to a Receiver or Preamp/Processor With aDedicated Subwoofer Output, on page 9.If you’re connecting to a receiver with left and right line outputs that are not connectedto amplifier inputs, connect the lFe (purple) connector of the supplied combination lFeand trigger cable to one of those outputs and to either of the HKTS 210SUB’s Line-LevelL/R In Connectors 7. Use a second RCA cable (not supplied) to connect the otherreceiver or preamp line output to the other of the HKTS 210SUB’s Line-Level L/R InConnectors 7.If you’re connecting to a receiver or preamp/processor with left and right lineoutputs that are connected to amplifier front left and front right inputs, connectthe single line outputs. Connect one of the y-adapter’s double ends to theHKTS 210SUB’s Line-Level L/R In Connectors 7, and connect the other double end toyour amplifier’s front left and right inputs.Connect each satellite speaker and the centre speaker to the corresponding speakerterminals on your receiver or amplifier.After you have made and verified all connections, plug the HKTS 210SUB’s AC PowerCord 9 into an active AC outlet.Left Front Right FrontRight SurroundLeft SurroundCentre