Harmonic Spectrum MediaPort 7000 Component Replacement Manual

Contents

Harmonic Spectrum MediaPort 7000 Component Replacement Manual Manual pdf 20 page image

MediaPort 7000 chassis replacement17 MediaPort Component Replacement GuideIMPORTANT: Before connecting a device to SystemManager, make sure that devicemonitoring is on. To check device monitoring, click the Home tab to open the Optionspage, and view the “Current state of Device Monitoring” field at the top of the page. Ifthe “Current state of Device Monitoring” field displays NOT monitoring, then click StartMonitoring and wait for the state to change to monitoring before continuing to connectthe device. This may take a few minutes depending on the number of devices in yoursystem. Also, note the status of devices may show Not Responding for a brief intervalafter monitoring has been turned on.9. Power up the MediaPort by plugging in both power cables.10. On the System Diagram page in SystemManager, verify that the new MediaPort appears asConnected.11. In SystemManager, view and clear any alarms that were created after the new MediaPort wasconnected.The replacement MediaPort will appear in SystemManager with the default name. For instructions onchanging the name, refer to "Changing an I/O module name" in this guide.12. Determine the firmware version running on the replacement MediaPort.NOTE: All devices in a Spectrum system should be running the same firmwareversion.13. If necessary, upgrade firmware on the replacement MediaPort to match that of the rest of yoursystem, and then reboot the MediaPort.14. Check the status LEDs on the front panel to ensure that the system is operating normally.Changing an I/O module nameRenaming can help you identify a MediaPort, ChannelPort, or Spectrum X module while navigating theSystemManager application.After replacing a MediaPort, the new device appears in SystemManager with the default name.NOTE: For information about proper naming conventions, please refer to "About NamingFiles and System Elements" in the Harmonic SystemManager User Guide.1. From the System Diagram, click the icon for the MediaPort that you wish to rename.The Properties page appears.2. At the top of the page, click Change Name.The Change I/O Module Name page appears.3. Type the new name in the field provided.4. Click Save.The new name now appears in the System Diagram, in various page titles and fields throughout theapplication.5. Repeat this procedure to rename another I/O module.