I.D. AL - VP100HDi - Interactive Full HD 1080p video player - User manual® Waves System V 1.03 - 20123 - INSTALLATION1 2 3 4 5 61 - USB Host connector to use aUSB flash memory or external harddisk or all other media with «massstorage» compatibility.2 - SD connector to use a SD/SDHC memory card.3 - Infrared sensor4 - Volume buttons5 - Status LED (red = sleep, orange= initialising, green = operationnal)6 - Sleep / wake up7 - Power supply input8 - VGA output (analog)9 - HDMI output (digital)10 - Ethernet RJ4511 - Analog stereo audio output12 - RS232 link13 - Trigger input14 - Power sypply out15 - Trigger output- 5 -4 - Operating mode4.1 -First useThe VP100HDi is delivered with default parameters. You need to change some parameters for an optimaluse like video out resolution, Ethernet link, time and date ...1 -Connect the VP100HDi to a display using HDMI or VGA out. Connect the power supply but don’t inserta media (SD or USB). Status LED change from red to orange and green for about 1 minute. Main menuis now displayed.2 -With the remote control, select «Setup» and change the parameters you want. (see the Setup chapter)Note : By default, the VP100HDi is set in Full HD output resolution (1920x1080). If your display is notcompatible with this resolution, you need to change the resolution. At this moment, may be, you can’t seeanything on the screen. Don’t worry, you can change dynamicaly the resolution using the «ACT» key onthe remote control.7 8 9 10 1112 13 14 15