15. Appendix9515.1.3 ISDB, ISPDB-MXL Weight [kg]200 W motor 200 W motorStroke WithoutbrakeWithbrakeB D E F WithoutbrakeWithbrake800 1241 1276 1113 3 14 122 18.3 18.8900 1341 1376 1213 3 14 222 19.6 20.11000 1441 1476 1313 4 16 122 20.9 21.41100 1541 1576 1413 4 16 222 22.2 22.71200 1641 1676 1513 5 18 122 23.4 23.91300 1741 1776 1613 5 18 222 24.7 25.21400 1841 1876 1713 6 20 122 26.0 26.51500 1941 1976 1813 6 20 222 27.3 27.81600 2041 2076 1913 7 22 122 28.6 29.149611051205.96542269941165.2556 5 53Stroke106 200WLB221119410M.E. S.E. M.E.HOME30008 20.0± 70860607025 2590 1515155155120D×20012060.5 90.5150.5120.53009 20.0±0960128 H7 0+0.0150160F873.43.71.5 4.56ØABDetail View A2- 8 H7, depth 10Referencesurface4-M8, depth 1810 (from the reference surface)2-oblong , depth 10Cable exit direction: RightGrease nipple for ball screwScrew for grounding wireconnection (M3 x 2 locations)Tapered tube screw (Rc 3/8)(Plug with plug screw; sameon the opposite side)Referencesurface 4- 8, H7 depth 10 E-M8 depth 20Slider center position (home)Cable exit direction: LeftCable lengthReferencesurfaceGrease nipple for guide(for supplying oil to the guide onthe installation surface side)B (Same on the opposite side of grease nipples)Tapered tube screw (Rc 3/8)(Plug with plug screw; sameon the opposite side)Cable exit direction: Rear141 (200W BK type)Base installation surface for high-precisionguide specificationMachining jig holes areprovided across the bottomsurface of the base.These holes are not used toinstall the actuator.Plug with rubber grommets.4-M6, depth 18