IBM 150P User Manual

IBM 150P User Manual Manual pdf 12 page image

10Device Driver InstallationDriver installation for Windows 95 or Windows 98This section must becompleted beforecontinuing with theWindows 95 or Windows 98Auto Setup on page 15To use the Plug and Play feature in Microsoft® Windows® 95 or Windows 98,files should be loaded from the IBM Monitor CD.1. Turn off the computer and all attached devices.2. Ensure that the monitor is connected correctly.3. Turn on the monitor and then the system unit. Allow the system to bootinto Windows 95 or Windows 98.Your computer’s Plug and Play code may warn you that your systemhardware has changed. This means that it has detected your newmonitor for the first time.4. Open the DISPLAY PROPERTIES window by clicking START, SETTINGS,CONTROL PANEL and then double - clicking on the DISPLAY icon.On LCD monitors, unlikeCRTs, a faster refresh ratedoes not improve display quality.IBM recommends using either1024 x 768 at a refresh rate of60Hz or 640 x 480 at a refreshrate of 60Hz.5. Click the SETTINGS tab.• In case of Windows 95 :6. 1. Click the CHANGE DISPLAY TYPE button.2. Click the CHANGE MONITOR TYPE button.• In case of Windows 98 :6. 1. Click the ADVANCED button.2. Click the MONITOR tab.3. Open the UPGRADE DEVICE DRIVER WIZARD window by clickingon CHANGE button and then select the NEXT button.4. Click the “Display a list of the known drivers for this device so thatI can choose a specific driver” and then select the NEXT button.7. Insert the Setup CD into the CD driver: and click the HAVE DISK button.8. Click OK.9. Ensure that the CD drive letter is selected.10. Choose IBM ThinkVision L150/150p monitor and Click OK. Thefiles will be copied from the CD to your hard disk drive.11. Close all open windows and remove the CD.12. Restart the system.The system will automatically select the maximum refresh rate andcorresponding Color Matching Profiles.L170_E.fm Page 8 Tuesday, February 11, 2003 12:51 AM