IISafety InformationDANGERTo avoid a shock hazard, do not connect or disconnect any cables or performinstallation, maintenance, or reconfiguration of this product during an electricalstorm.To avoid shock hazard:• The power cord must be connected to a properly wired and earthedreceptacle.• Any equipment to which this product will be attached must also beconnected to properly wired receptacles.When possible, use one hand to connect or disconnect signal cables toprevent a possible shock from touching two surfaces with different electricalpotentials.Electrical current from power, telephone, and communications cables ishazardous. To avoid shock hazard, connect and disconnect cables asdescribed following when installing, moving, or opening covers of this productor attached devices.CAUTION: When replacing the battery, use only IBM Part Number 33F8354 oran equivalent type battery recommended by the manufacturer. If yoursystem has a module containing a lithium battery, replace it only with thesame module type made by the same manufacturer. The batterycontains lithium and can explode if not properly used, handled, ordisposed of.Do not:• Throw or immerse into water• Heat to more than 100°C (212°F)To Connect To Disconnect1. Turn Everything OFF. 1. Turn Everything OFF.2. First, attach all cables to devices. 2. First, remove power cord(s) from outlet3. Attach signal cables to receptacles. 3. Remove signal cables from receptacles.4. Attach power cord(s) to outlet. 4. Remove all cables from devices.5. Turn device ON
