IBM 326m - eServer - 7969 Hardware Maintenance Manual

Also see for 326m - eServer - 7969: Installation guide

Contents

CD-ROM driveComplete the following steps to remove the CD-ROM drive.Note:v Read “Installation guidelines” on page 29.v Read the safety notices at “Safety information” on page 107.v Read “Handling static-sensitive devices” on page 30.1. Turn off the server and all attached devices.2. Disconnect all power cords and external cables from the back of the server.3. Remove the server from the rack.4. Remove the server cover (see “Removing the cover and bezel” on page 32);then, take out the air baffle.5. Remove the four microprocessor fans, making note of their orientation for laterreplacement.6. Disconnect the CD-ROM drive power cable from the system board.7. Disconnect the IDE cable from the CD-ROM drive.8. Press the release cam until the media tray protrudes slightly from the front ofthe server.Release camMedia trayCD-ROMdisk driveInterposercardRetainer wireHolesRetention tab9. Carefully pull the drive assembly out of the chassis.10. Remove the retaining wires on the drive assembly.11. To remove the CD-ROM drive from the media tray, pull gently on the drive andslide it out of the tray.12. To remove the interposer card, remove the screw that secures it to the mediatray and pull the card away from the media tray.To replace the CD-ROM drive, reverse the previous steps.Chapter 6. Service replaceable units 65