Installing a USB hypervisor memory keyHypervisor is a virtualization platform that enables multiple operating systems to runon a host computer at the same time. Support for hypervisor is available with thepurchase and installation of an optional USB hypervisor memory key, withembedded hypervisor software.To install the USB hypervisor memory key, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 37.2. Turn off the server and peripheral devices and disconnect all power cords andexternal cables (see “Turning off the server” on page 22).3. Remove the cover (see “Removing the cover” on page 44).4. Locate the SAS riser-card assembly, which is near the left front corner of theserver.5. Push the blue locking collar on the USB hypervisor connector on the SASriser-card toward the SAS riser-card (the unlocked position).6. Insert the hypervisor memory key into the USB hypervisor connector.7. Slide the blue lock on the USB hypervisor connector forward toward thehypervisor memory key as far as it will go, to secure the memory key inposition.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 139.Note: You must configure the server to boot from the hypervisor USB drive. SeeChapter 3, “Configuring the server,” on page 143 for information about enabling theembedded hypervisor.Chapter 2. Installing optional devices 133
