v If you install a different type of RAID controller, see the documentation thatcomes with the controller for information about viewing and changing settingsfor attached devices.Starting the LSI Configuration Utility programUse these instructions to start the LSI Configuration Utility program.To start the LSI Configuration Utility program, complete the following steps:1. Turn on the blade server, and make sure that the blade server is the owner ofthe keyboard, video, and mouse.2. When the <<>>prompt is displayed, press Ctrl+C.3. Use the arrow keys to select the controller from the list of adapters; then, pressEnter.4. Follow the instructions on the screen to change the settings of the selecteditems; then, press Enter. If you select SAS Topology or Advanced AdapterProperties, additional screens are displayed.When you have finished changing settings, press Esc to exit from the program;select Save to save the settings that you have changed.Note: For more information, see the Installation and User's Guide for ServeRAIDH1135 at http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5088601&brandind=5000008.Starting the Human Interface Infrastructure (HII) ConfigurationApplicationUse these instructions to start the HII Configuration Application.To start the HII Configuration Application, complete the following steps:1. Turn on the blade server, and make sure that the blade server is the owner ofthe keyboard, video, and mouse.Note: Approximately 20 to 40 seconds after the server is connected to power,the power-control button becomes active.2. When the prompt is displayed, press F1. If you have set anadministrator password, you are prompted to type the password.3. Select System Settings → Storage.4. Under Storage, select the ServeRAID adapter you want to configure and pressEnter to continue.When you have finished changing settings, press Esc to exit from the program;select Save to save the settings that you have changed.Note: For more information, see the Installation and User's Guide for ServeRAIDH1135 at http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5088601&brandind=5000008.Creating a RAID array of hard disk drivesUse this information to create a RAID array of hard disk drives.To create a RAID array of hard disk drives, complete the following steps:60 BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide |
