IBM 8832L1X Maintenance And Troubleshooting Manual

Contents

48 Intel® Server Compute Blade SBX82: Hardware Maintenance Manual and Troubleshooting Guidea. Loosen one captive screw fully; then, loosen the other captive screw.Attention: Loosening one screw fully before loosening the other screw will help to breakthe thermal bond that adheres the heat sink to the microprocessor.b. Gently pull the heat sink off of the microprocessor.7. Rotate the locking lever on the microprocessor socket from its closed and locked position(Figure 14) until it stops or clicks in the fully open position (approximately 135° angle), asshown in Figure 15.Attention: You must ensure that the locking lever on the microprocessor socket is in the fullyopen position before you remove the microprocessor from or insert the microprocessor into thesocket. Failure to do so might result in permanent damage to the microprocessor, microprocessorsocket, and system board.8. Pull the microprocessor out of the socket.Figure 14. Microprocessor locking lever in the closedpositionFigure 15. Microprocessor locking lever in the fullyopen positionLever closedLever closedLeverfullyopenLeverfullyopen