IBM NetVista Hardware Maintenance Manual

Contents

62Table 2-1 BIOS Error Codes, Messages, and Beeps ListBIOS Error Codes,Messages, beepsAction/FRUNOTE: To diagnose a problem, first find the BIOS error messages, codes, or beeps in left column. If directed to a checkprocedure, replace the FRU indicated in the check procedure. If no check procedure is indicated, the first Action/FRU listedin right column is the most likely cause.1762Primary master IDE haschangedPrimary slave IDE has changedSecondary master IDE haschangedSecondary slave IDE haschangedMake sure that the System Boot Drive parameter in the Startup Options of BIOS Setup isnot set to [Drive A only].Load default settings in Setup.Insert a system diskette into diskette drive and reboot system.Make sure the diskette drive configuration setting in BIOS Setup is correct.Hard disk drives power.Diskette drive.System board.1780Primary master hard diskfailure1781Primary slave hard disk failureA warning message to indicate there has been a change of IDE Primary (Secondary)Channel Master (Slave) device.Load default settings in Setup.Check IDE drive jumper. See “3.5-In. Hard Disk Drive Jumper Locations” on page 126.IDE drive power.IDE drive cable/connection.IDE drive.1782Secondary master hard diskfailure1783Secondary slave hard diskfailureA warning message to indicate there has been change of IDE Primary (Secondary)Channel Master (Slave) device.Load default settings in Setup.Check IDE drive jumper. See ”3.5-In. Hard Disk Drive Jumper Locations” on page 126.IDE drive power.IDE drive cable/connection.IDE drive.8602Mouse error on no MousepresentMake sure the Mouse is connected properly and is set correctly in BIOS Setup.Mouse.System board.SYSTEM HALTED, (CTRL-ALT-DEL) TO REBOOT…Indicates the present boot attempt has been aborted and the system must be rebooted.Press and hold down the CTRL and ALT key and DEL.Hard Disk(s) failure (80) Hard Disk Drive reset failed.Hard Disk(s) failure (40) Hard Disk Drive controller diagnostics failed.Hard Disk(s) failure (20) Hard Disk Drive initialization error.Hard Disk(s) failure (10) Unable to recalibrate fixed disk.Non-System disk or disk errorReplace and strike any keywhen readyInsert a system disk into Drive A: and press <Enter>.If you assumed the system would boot from the hard drive, make sure the controller isinserted correctly and all cables are properly attached.Be sure the disk is formatted as a boot device. Then reboot the system.OFFENDING SEGMENT: This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITYERROR messages when the segment that has caused the problem has been isolated.PRESS A KEY TO REBOOT This will be displayed at the bottom of the screen when an error occurs that requires you toreboot. Press any key and the system will reboot.