IBM NetVista N2200l Manual

Contents

Setting up the hardwareThe IBM NetVista Quick Setup for NetVista N2200l (SA23-2809) pamphlet, which ships with your hardware, providesthe following information. This section goes into more detail for your convenience.Read “Safety notices” on page v before you continue with these instructions.Unpacking the hardwareUnpack the hardware. Contact your reseller, or IBM, ifyou do not have these standard parts:1 Logic unit2 Base3 Mouse4 USB Keyboard5 Power supply6 Power cableOption: If you would like to restrict access to the logicunit, you can thread a security cable through tab A.Installing the support baseRead “Safety notices” on page v before you continue withthese instructions.IBM recommends that you install the hardware in avertical position.1. Align the notches B on the support base C withthe holes on the bottom of the logic unit D.2. Slide the support base C onto the bottom of thelogic unit D.To remove the support base C, lift the latch E onthe support base and slide the support base off thelogic unit D.© Copyright IBM Corp. 2001 5