IBM System x3500 Service Manual

Also see for x3500 - System - 7977: Brochure User guide Configuration and options guide Installation guide User guide

Contents

197 This is a warning error, but it does not indicate a hardware failure; do notreplace a CRU or FRU. Take the action that is indicated in the Actioncolumn, but do not replace a CRU or a FRU. See the description ofWarning in “Diagnostic text messages” on page 140 for more information.v Follow the suggested actions in the order in which they are listed in the Action column until the problemis solved.v See Chapter 3, “Parts listing, System x3500 Type 7977,” on page 41 to determine which components arecustomer replaceable units (CRU) and which components are field replaceable units (FRU).v If an action step is preceded by “(Trained service technician only),” that step must be performed only by atrained service technician.Error code Description Action001-198-000 Test aborted. 1. Check the diagnostic logs for messages thatindicate the cause of the error, and take theindicated action.2. From the diagnostic programs, run Quick MemoryTest All Banks; then, if an error is detected, takethe indicated action.3. Reinstall and, if necessary, update the BIOS codeon the server; then, run the test again (see“Updating the firmware” on page 13).001-250-001 Failed system board ECC (Trained service technician only) Replace systemboard.001-292-000 Core system: failed/CMOS checksum failed. Load the BIOS default settings by using theConfiguration/Setup Utility program, and run the testagain (see “Using the Configuration/Setup Utilityprogram” on page 14).005-xxx-000 Failed video test. 1. Reseat the video adapter, if one is installed.2. (Trained service technician only) Replace thesystem board.011-xxx-000 Failed COM1 serial port test. (Trained service technician only) Replace the systemboard.015-xxx-001 Failed USB test. (Trained service technician only) Replace the systemboard.015-xxx-198 Remote Supervisor Adapter II SlimLineinstalled or USB device connected duringUSB test.1. If a Remote Supervisor Adapter II SlimLine isinstalled as an option, remove it and run the testagain.2. Remove all USB devices and run the test again.3. (Trained service technician only) Replace thesystem board.035-285-001 Adapter Communication Error 1. Update the RAID controller firmware.2. Reseat, and if necessary replace the controller.035-286-001 Adapter CPU Test Error 1. Update the RAID controller firmware.2. Reseat, and if necessary replace the controller.035-287-001 Adapter Local RAM Test Error 1. Update the RAID controller firmware.2. Reseat, and if necessary replace the controller.035-288-001 Adapter NVSRAM Test Error 1. Update the RAID controller firmware.2. Reseat, and if necessary replace the controller.Chapter 5. Diagnostics 141