2. Turn on the server.Note: Approximately 20 to 40 seconds after the server is connected to power,the power-control button becomes active.Obtaining the IP address for the IMMTo access the Web interface, you need the IP address for the IMM. You can obtainthe IMM IP address through the Setup utility. The server comes with a default IPaddress for the IMM of 192.168.70.125. To locate the IP address, complete thefollowing steps:1. Turn on the server.Note: Approximately 20 to 40 seconds after the server is connected to power,the power-control button becomes active.2. When the prompt Setup is displayed, press F1. (This prompt is displayedon the screen for only a few seconds. You must press F1 quickly.) If you haveset both a power-on password and an administrator password, you must typethe administrator password to access the full Setup utility menu.3. From the Setup utility main menu, select System Settings.4. On the next screen, select Integrated Management Module.5. On the next screen, select Network Configuration.6. Find the IP address and write it down.7. Exit from the Setup utility.Logging on to the Web interfaceTo log on to the Web interface to use the remote presence functions, complete thefollowing steps:1. Open a Web browser on a computer that connects to the server and in theaddress or URL field, type the IP address or host name of the IMM to whichyou want to connect.Note: The IMM defaults to DHCP. If a DHCP host is not available, the IMMassigns a static IP address of 192.168.70.125.2. On the Login page, type the user name and password. If you are using the IMMfor the first time, you can obtain the user name and password from your systemadministrator. All login attempts are documented in the event log.Note: The IMM is set initially with a user name of USERID and password ofPASSW0RD (passw0rd with a zero, not the letter O). You have read/writeaccess. You must change the default password the first time you log on.3. On the Welcome page, type a timeout value (in minutes) in the field that isprovided. The IMM will log you off of the Web interface if your browser isinactive for the number of minutes that you entered for the timeout value.4. Click Continue to start the session. The System Health page provides a quickview of the system status.Enabling the Broadcom Gigabit Ethernet Utility programThe Broadcom Gigabit Ethernet Utility program is part of the server firmware. Youcan use it to configure the network as a startable device, and you can customizewhere the network startup option appears in the startup sequence. Enable anddisable the Broadcom Gigabit Ethernet Utility program from the Setup utility.120 IBM System x3550 M3 Types 4254 and 7944: Installation and User’s Guide
