Logging on to the Web interfaceUse this information to log on to the web interface.About this taskTo log onto the Web interface to use the remote presence functions, complete thefollowing steps:Procedure1. Open a Web browser on a computer that connects to the server and in theAddress or URL field, type the IP address or host name of the IMM to whichyou want to connect.Note: The IMM defaults to DHCP. If a DHCP host is not available, the IMMassigns a static IP address of 192.168.70.125.2. On the Login page, type the user name and password. If you are using theIMM for the first time, you can obtain the user name and password from yoursystem administrator. All login attempts are documented in the event log.Note: The IMM is set initially with a user name of USERID and password ofPASSW0RD (passw0rd with a zero, not the letter O). You have read/writeaccess. You must change the default password the first time you log on.3. On the Welcome page, type a timeout value (in minutes) in the field that isprovided. The IMM will log you off of the Web interface if your browser isinactive for the number of minutes that you entered for the timeout value.4. Click Continue to start the session. The System Health page provides a quickview of the system status.Using the embedded hypervisorThe VMware ESXi embedded hypervisor is available on server models that comewith an installed USB embedded hypervisor flash device.About this taskThe USB flash device comes installed in the USB connector on the SAS/SATARAID riser card (see the following illustration). Hypervisor is virtualizationsoftware that enables multiple operating systems to run on a host system at thesame time. The USB flash device is required to activate the hypervisor functions.To start using the embedded hypervisor functions, you must add the USB flashdevice to the boot order in the Setup utility.Figure 93. USB embedded hypervisor flash device connectorChapter 3. Configuring the server 125
