USB hypervisorconnectorPCI Express SAScontroller connectorSAS controllererror LEDSAS risercardTo start using the embedded hypervisor functions, you must add the USB memorykey to the startup sequence in the Setup utility.To add the USB hypervisor memory key to the boot order, complete the followingsteps:1. Turn on the server.Note: Approximately 3 minutes after the server is connected to ac power, thepower-control button becomes active.2. When the prompt Setup is displayed, press F1.3. From the Setup utility main menu, select Boot Manager.4. Select Add Boot Option; then, select Hypervisor. Press Enter, and then pressEsc.5. Select Change Boot Order and then select Commit Changes; then, pressEnter.6. Select Save Settings and then select Exit Setup.If the embedded hypervisor image becomes corrupt, you can use the VMwareRecovery CD that comes with the server to recover the image. To recover the flashdevice image, complete the following steps:1. Turn on the server.Note: Approximately 3 minutes after the server is connected to ac power, thepower-control button becomes active.2. Insert the VMware Recovery CD into the CD or DVD drive.3. Follow the instructions on the screen.For additional information and instructions, see the VMware ESXi Server 3iEmbedded Setup Guide at http://www.vmware.com/pdf/vi3_35/esx_3i_e/r35/vi3_35_25_3i_setup.pdf/.Using the remote presence capability and blue-screen captureThe remote presence and blue-screen capture features are integrated functions ofthe integrated management module (IMM). When an optional virtual media key isinstalled in the server, it activates full systems-management functions. The virtualmedia key is required to enable the integrated remote presence and blue-screencapture features. Without the virtual media key, you cannot remotely mount orunmount drives or images on the client system. However, you still can access theWeb interface without the key.After the virtual media key is installed in the server, it is authenticated to determinewhether it is valid. If the key is not valid, you receive a message from the Webinterface (when you attempt to start the remote presence feature) indicating that thehardware key is required to use the remote presence feature.154 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide
