IBM T84H Setup Manual

Contents

IBM T84H Setup Manual Manual pdf 12 page image

13DEUTSCH ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARRManual SetupNormally, you can complete the setup procedure using AUTO SETUP, however,if your screen image is still distorted after you perform AUTO SETUP or thesetup diskette does not run on your system, perform MANUAL SETUP.If the monitor is in standbymode (STANDBY ON), itmight automatically turn offwhile you are waiting for it towarm up.1. Have your monitor turned on for about 15 minutes, until the monitorwarms up.2. Display the image you most frequently use on the screen.3. Press the OSD Enter button at the bottom of the monitor to displaythe initial OSD menu.4. Use an Arrow button ( or ) to select the IMAGE LOCK iconand press the OSD Enter button to access the function.5. Using an Arrow button ( or ), select MANUAL, press and thenpress once to select COARSE. Left and right arrow adjustmentindicators become illuminated (see page 18).6. Use the Arrow buttons to manually adjust to correct (as much aspossible) for noise in the video signal then press to save thechanges.7. Use an Arrow button to select FINE and press the button.8. Use the Arrow buttons again to tune the image to your liking.9. When finished, press the Exit button four times to exit from theOSD.You have completed the monitor setup.T84H_setup0926_final.fm Page 13 Thursday, October 5, 2000 8:45 AM