IBM eServer pSeries 610 6C1 Installation Manual

Also see for 6C1: Technical overview and introduction Technical overview and introduction Service guide

Contents

Removing Memory DIMMs1. If you have not already done so, shut down the system as described in “Stoppingthe System Unit” on page 34.2. If you have not already done so, unplug the system unit power cables from theelectrical outlets.3. If your server is a Model 6C1 (rack mount), place the server in the service positionas described in “Placing the Model 6C1 in the Service Position” on page 35.4. If you have not already done so, remove the service access cover as described in“Removing the Service Access Covers” on page 37.5. If you have not already done so, remove the processor and memory card cover asdescribed in “Removing and Replacing Processor and Memory Card Cover” onpage 41.6. If you have not already done so, remove the memory card as described in“Removing a Memory Card” on page 487. Locate the memory DIMM connectors and determine which DIMM you want toremove.Slot J1Slot J3Slot J4Slot J2Slot J5Slot J6Slot J9 Slot J10Slot J11 Slot J12Slot J13 Slot J14Slot J15 Slot J16Slot J7Slot J8Note: Memory DIMMs must be removed in pairs and in the correct slotconfiguration. (Slots J1 and J2, J3 and J4, J5 and J6, and so on.)52 Installation Guide