IBM p5 520 Quick Start Manual

8.88.6At the login prompt, enter the following default user ID and password:In the navigation area, expand .Click .Select in the Boot to system server firmware field.Click .Power/Restart ControlPower On/Off SystemStandbySave settings and power onUser IDadminPasswordadminConfigure the Ethernet interface on the PC to an IP address and subnet maskwithin the same subnet as the server. This is the IP address for the serviceprocessor.Server connectorHMC1HMC2Subnet mask255.255.255.0255.255.255.0IP address192.168.2.147192.168.3.147For example, if you connected your PC to HMC1, the IP address for your serviceprocessor might be 192.168.2.1 and the subnet mask would be 255.255.255.0. Setthe gateway IP address to the same IP address as that of the PC.Using a Web browser, enter the IP address into the field that correspondsto the port to which your PC is connected. For example, enter https://192.168.2.147.AddressPossible values:Note: If you do not know how to do this, see the instructions in the IBM SystemsHardware Information Center. For details about how to access the informationcenter, see task 9 Finish your system setup.When you are prompted, change the default password.8.78.108.91.2.3.4.Change the state of the system server firmware.8.5 If this server is installed in a rack, route the cables through the cable-management arm and secure the cables to the cable-management arm.