Modified /boot/grub/menu.lst contents Notestitle floppyrootchainloader +1title failsafekernel (hd0,1)/boot/vmlinuz.shipped root=/dev/hda2 ide=nodma apm=off vga=normal nosmp 1disableapic maxcpus=0 3initrd (hd0,1)/boot/initrd.shippedNote 1: The kernel line is shown with a line break. In your file, the entire entry must all be on one line.You must restart the Linux operating system after completing these procedures forthe changes to take effect and to enable SOL.Microsoft Windows 2003 Standard Edition configuration:Note: This procedure is based on a default installation of the Microsoft ® Windows ®2003 operating system.To configure the Windows 2003 operating system for SOL operation, complete thefollowing steps. You must be logged in as a user with administrator access toperform this procedure.1. Determine which boot entry ID to modify:a. Type bootcfg at a Windows command prompt; then, press Enter to displaythe current boot options for your server.b. In the Boot Entries section, locate the boot entry ID for the section with anOS friendly name of Windows Server 2003, Standard. Write down the bootentry ID for use in the next step.2. To enable the Microsoft Windows Emergency Management System (EMS), at aWindows command prompt, typebootcfg /EMS ON /PORT COM1 /BAUD 19200 /ID boot_idwhere boot_id is the boot entry ID from step 1b; then, press Enter.3. Verify that the EMS console is redirected to the COM1 serial port:a. Type bootcfg at a Windows command prompt; then, press Enter to displaythe current boot options for your server.b. Verify the following changes to the bootcfg settings:v In the Boot Loader Settings section, make sure that redirect is set toCOM1 and that redirectbaudrate is set to 19200.v In the Boot Entries section, make sure that the OS Load Options: linehas /redirect appended to the end of it.The following examples show the original bootcfg program output and the outputafter modification.Chapter 2. Configuration information and instructions 29
