IBM x3850 X6 Installation Instructions Manual

Also see for System x3950 X6: Product guide Installation and service guide Product guide Planning and implementation guide

Contents

Note: Do not tighten the M5 hex head screws complete.5. After the bottom shipping bracket and screws are installed, tighten all of thescrews.Attaching the cable management brackets and routing the cablesThis topic provides information about how to attach the cable managementbrackets to the server and route the cables.About this taskNote: These instructions apply to both the 4U and 8U server models. Only the 4Uis shown in the illustrations.The server comes with cable management brackets to hold the cables in place andprevent them from sagging or getting pinched and damaged. The cablemanagement bracket prevents the cables from being pulled to tight and assists inproviding the correct tension on the cable and routing of the cables. The cablemanagement brackets snap on both sides of the server and contain an opening(slot) for a hook and loop strap. The hook and loop strap is used to hold the cablesin place.To attached the cable management brackets and route the cables, complete thefollowing steps:1. Align the cable management brackets with the server and snap them in place.The following illustration shows the rear of the server with the cablemanagement brackets installed.Cablemanagementbracket2. Attach the power cords and other cables to the rear of the server (includingkeyboard, monitor, and mouse cables (if required).3. Route the cables and power cord through the hook and loop straps on the cablemanagement brackets.Notes:Chapter 3. Rack installation 15