1010741094810. Untie and discard the wire tie on the MainWire (48).While a second person holds the Console (7)near the Upright (4), plug the Main Wire (48) andthe Pulse Wire (109) into the matching recep-tacles on the back of the Console.The connectors on the Main Wire (48) andthe Pulse Wire (109) should slide easily intothe receptacles and snap into place. If a con-nector does not slide easily into a receptacle,turn the connector and try again. If you do notconnect the connectors properly, the consolemay become damaged.Insert the excess wire into the Upright (4) or intothe Console (7).99. The Console (7) can use four D batteries (notincluded); alkaline batteries are recommended.Do not use old and new batteries together oralkaline, standard, and rechargeable batter-ies together. IMPORTANT: If the Console hasbeen exposed to cold temperatures, allowit to warm to room temperature before youinsert batteries. Otherwise, you may dam-age the console displays or other electroniccomponents. Remove the screws (D) and thebattery covers (E), insert batteries into the bat-tery compartments, and then reattach the batterycovers. Make sure to orient the batteries asshown by the diagrams inside the batterycompartments.To purchase an optional power adapter, callthe telephone number on the cover of thismanual. To avoid damaging the Console (7),use only a manufacturer-supplied regulatedpower adapter. Plug one end of the poweradapter into the receptacle (F) inside the indi-cated battery compartment, and route the poweradapter through the notch (G) in the batterycover. Then, plug the other end into an outletinstalled in accordance with all local codes andordinances.7DEFG