ICP GDT8500RZ Installation And User Manual

Also see for GDT8500RZ: Specification

ICP GDT8500RZ Installation And User Manual Manual pdf 24 page image

24Hardware Installation and User’s GuideFlash Memory Programming10. After the file transfer is complete, remove the firmware diskette from the computerand label it.A.4.2 Creating Firmware Diskettes from the Bootable RAIDSoftware Suite CD-ROM1. If necessary, change your computer’s BIOS setting so that the system boots from theCD-ROM.2. Boot the computer from the RAID Software Suite CD-ROM.3. Select ‘Create Diskettes’ and press Enter.4. Select ‘Firmware Diskettes’ and press Enter.5. Select ‘Bootable Firmware Recovery Floppy’ and press Enter.6. Insert a blank floppy Diskette, then select ‘Yes’ and press Enter to begin the filetransfer.7. After the file transfer is complete, select ‘OK’, then press Enter.8. Remove the first diskette and label it.9. From a computer that has an internet connection, download the latest firmware filefrom http://www.icp-vortex.com or http://www.vortex.de and copy it to a secondfloppy diskette. Proceed to Section A.4.3 for information on running the FRUU.ORInsert a second blank diskette into the computer, then complete the remaining steps inthis procedure.10. Select ‘Create Diskettes’ and press Enter.11. Select ‘Firmware Diskettes’ and press Enter.12. Select ‘Firmware File’ and press Enter.13. Verify that your second blank floppy Diskette is inserted, then select ‘Yes’ and pressEnter to begin the file transfer.14. After the file transfer is complete, select ‘OK’, then press Enter.15. Remove the first diskette and label it.16. Proceed to Section A.4.3 for information on running the FRUU.A.4.3 Running the FRUU1. Choose between firmware update and firmware recovery. See Section A.2.2. Set the ICP RAID controller’s IOP to normal for firmware updates or to reset forfirmware recovery. See Section A.3.3. If running the FRUU from the RAID Software Suite CD-ROM, change yourcomputer’s BIOS setting so that your system boots from the CD-ROM.