IEI Technology AFL-W19A User Manual

Also see for AFL-W19A: User manual User manual User manual

AFL-W19A/W19B/17D/W15A-GM45 Panel PCPage 18Figure 2–6: CompactFlash® InstallStep 4: Slide the cover back on, then fasten the screw.Step0:2.5 Jumper SettingsNOTE:A jumper is a metal bridge that is used to close an electrical circuit. Itconsists of two metal pins and a small metal clip (often protected by aplastic cover) that slides over the pins to connect them. ToCLOSE/SHORT a jumper means connecting the pins of the jumperwith the plastic clip and to OPEN a jumper means removing the plasticclip from a jumper.The motherboard jumpers are listed below. COM1 pin 9 setup COM3 pin 9 setup COM3 RS-232/422/485 selection2.5.1 COM1 Pin-9 SetupJumper Label: JP11Jumper Type: 10-pin header