IBX-700 Integrated Service ComputerPage 123Step 1: Check that the power cable connector is properly connected to the terminalblock or power socket on the system rear panel.Step 2: Check that the power cable connector is properly plugged into the power source.Step 3: Make sure the power button is turned on.Step 4: Plug the system into a monitor and check to see if anything appears on thescreen. If the boot-up screen appears it means the power LED has becomedisconnected. To fix this problem, remove the cover case and reconnect thepower LED to the motherboard. Step 0:If the above steps have been completed and the system still doesn’t turn on, please do thefollowing.Step 1: Remove the cover case (Section 8.3.1).Step 2: Check the terminal block/power socket power cable connector is properlyconnected to the power module.Step 3: Check that the power switch cable connector is properly connected to themotherboard.Step 4: Make sure the cable connecting to the terminal block/power socket are properlyattached and have not become separated.Step 5: Make sure the cable connecting the power switch to the motherboard is stillproperly attached to the power switch and has not been separated. Step 0:8.2.2 The System Doesn’t Boot UpIf the system doesn’t boot up please do the following:Step 1: Check the power is turned on. See Section 8.2.1 above.Step 2: Make sure the DIMM module is properly installed.Step 3: Reset the system using the reset CMOS jumper. Step 0:
