IEI Technology IMB-9452 User Manual

Also see for IMB-9452: User manual

Contents

IEI Technology IMB-9452 User Manual Manual pdf 82 page image

Page 82 IEI® Technology, Corp.IMB-9452 Motherboardo When installing or configuring the motherboard, place it on an antistaticpad. This helps to prevent potential ESD damage. Turn off all power to the IMB-9452o When working with the motherboard, make sure that it is disconnectedfrom all power supplies and that no electricity is being fed into the system.Before and during the installation of the IMB-9452 DO NOT: remove any of the stickers on the PCB board. These stickers are required forwarranty validation. use the product before verifying all the cables and power connectors areproperly connected. allow screws to come in contact with the PCB circuit, connector pins, or itscomponents.4.3 UnpackingNOTE:If any of the items listed below are missing when the IMB-9452 isunpacked, do not proceed with the installation and contact the IMB-9452reseller or vendor.4.3.1 Unpacking PrecautionsBefore installing the IMB-9452, unpack the motherboard. Some components on IMB-9452are very sensitive to static electricity and can be damaged by a sudden rush of power. Toprotect it from being damaged, follow these precautions: The user should ground them self to remove any static charge beforetouching the IMB-9452. To do so wear a grounded wrist strap at all times orfrequently touch any conducting materials that is connected to the ground. Handle the IMB-9452 by its edges. Do not touch the IC chips, leads orcircuitry if not necessary.