ITCS -100-H81 Em b e dd e d S ys te mP a g e 334.3.5 S ATA Co n fig u ra tio nUse the SATA Configuration menu (BIOS Menu 7) to change and/or set theconfiguration of the SATA devices installed in the system.Aptio Setup Utility – Copyright (C) 2016 American Megatrends, Inc.AdvancedSATA Controller [Enabled]SATA Mode Selection [ACHI]SATA Port 1 EmptyHot Plug [Disabled]SATA Port 2 EmptyHot Plug [Disabled]On Board SSD 4GB NANDrive (3.9GB)Hot Plug [Disabled]M-SATA Port EmptyHot Plug [Disabled]Enable/Disable SATADevice.---------------------: Select Screen↑ ↓: Select ItemEnter SelectF1 General HelpF2 Previous ValuesF3 OptimizedDefaultsF4 SaveESC ExitVersion 2.17.1249. Copyright (C) 2016 American Megatrends, Inc.BIOS Menu 7: IDE Configuration S ATA Co n tro lle r [En a b le d ]Use the SATA Controller option to enable or disable the SATA device. Disabled Disables the SATA device. Enabled D EFAULT Enables the SATA device. S ATA Mo d e S e le c tio n [AHCI]Use the SATA Mode Selection option to configure SATA devices as AHCI devices. IDE D EFAULT Configures SATA devices as normal IDE device. AHCI D EFAULT Configures SATA devices as AHCI device. Ho t P lu g [Dis a b le d ]Use the Hot Plug option to configure the port as Hot Pluggable.
