NANO-ULT3 SBCPage 48WARNING:The installation instructions described in this manual should be carefullyfollowed in order to prevent damage to the NANO-ULT3, NANO-ULT3components and injury to the user.Before and during the installation please DO the following: Read the user manual:o The user manual provides a complete description of the NANO-ULT3installation instructions and configuration options. Wear an electrostatic discharge cuff (ESD):o Electronic components are easily damaged by ESD. Wearing an ESD cuffremoves ESD from the body and helps prevent ESD damage. Place the NANO-ULT3 on an antistatic pad:o When installing or configuring the motherboard, place it on an antistaticpad. This helps to prevent potential ESD damage. Turn all power to the NANO-ULT3 off:o When working with the NANO-ULT3, make sure that it is disconnectedfrom all power supplies and that no electricity is being fed into the system.Before and during the installation of the NANO-ULT3 DO NOT: Remove any of the stickers on the PCB board. These stickers are required forwarranty validation. Use the product before verifying all the cables and power connectors areproperly connected. Allow screws to come in contact with the PCB circuit, connector pins, or itscomponents.
