WAFER-OT-Z650/Z670 3.5" MotherboardPage 113BIOS SETUP UTILITYMain Advanced PCIPNP Boot Security Chipset ExitiEi Feature⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯Auto Recovery Function [Enabled]Recover from PXE [Disabled]ÅÆ Select Screen↑ ↓ Select ItemEnter Go to SubScreenF1 General HelpF10 Save and ExitESC Exitv02.61 ©Copyright 1985-2006, American Megatrends, Inc.BIOS Menu 16: IEI FeatureStep 13: Save changes and restart the system. If the system encounters a Blue Screen ofDeath (BSoD) or a hang for around 10 minutes, it will automatically restore fromthe factory default image.B.4 Setup Procedure for LinuxThe initial setup procedures for a Linux system are mostly the same with the procedure forMicrosoft Windows. Please follow the steps below to setup the recovery tool for Linux OS.Step 1: Hardware and BIOS setup. Refer to Section 7 7 B.2.1.Step 2: Install Linux operating system. Make sure to install GRUB (v0.97 or earlier)MBR type and Ext3 partition type. Leave enough space on the hard drive tocreate the recover partition later.NOTE:If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,the Symantec Ghost may not function properly.While installing Linux OS, please create two partitions:
