IKA HB digital Manual

Also see for HB digital: Operating instructions Operating instructions Operating instructions Instruction manual

14 15/// Setting the target temperature/// Setting the operating modesActivate the SET function by turning and pressing the rotating/pressing knob�� Switch on the device using the mains switch, when the opening screen (Fig� 5) appears andthe setting for the safety temperature is activated for 5 seconds� “SAFE TEMP�“ flashes on thedisplay, see also “Setting the safety temperature“�� The display then switches from “SAFE TEMP�“ to “TEMP�“ and the SET function is activated�(Fig� 6)� Set the desired heating bath temperature by turning the rotating/pressing knob�� The SET function flashes every few seconds�� Confirm the value by pressing the rotating/pressing knob�� If not confirmed, the set value is not saved�� The SET function stops flashing�� Start the heating process by pressing the rotating/pressing knob�Operating mode A� Switch on the device at the mains switch�� The heating function is switched off�� Safe Temp (safety temperature) will appear for 5 seconds�� The target value is set to 20 °C�� The controller tempering medium is set to water�SETATEMP.°C...SETATEMP.°CSETATEMP.°CSETATEMP.°COIL... ::... OILiTEMP.SETATEMP.°C°CSETATEMP.°C°CSETATEMP.°CSETATEMP.°C°C