Daily useIgnition of the burnersAlways ignite the burners before posi-tioning pots or pans.To ignite the burner:1. Push the relevant control knob com-pletely in and turn it counter-clockwiseto the maximum position marked .2. Keep the knob pushed for about 5 sec;this will allow thermocouple to heat up,and the safety device to switch off, oth-erwise the gas supply would be inter-rupted.3. After the flame is regular, adjust it aspreferred.If after a few attempts the burner doesnot ignite, check that the crown and itscap are in correct positions.342112341 Burner cap2 Burner crown3 Ignition candle4 ThermocoupleWarning! Do not keep control knobpressed for more than 15 seconds.If the burner does not light after 15 seconds,release the control knob, turn it into off posi-tion and wait for at least 1 minute beforetrying to light the burner again.Important! In the absence of electricity Youcan ignite the burner without electricaldevice; in this case approach the burnerwith a flame, push the relevant knob downand turn it counter-clockwise to maximumgas release position.ENGLISH 6