IKEA ICS300WM00 Use And Care Manual

Also see for ICS300WM00: Installation instructions

Contents

PARTSAND FEATURESThis manual covers different models. The cooktop you havepurchased may have some or all of the items listed. The locationsand appearances of the features shown here may not matchthose of your model.Control Panelfo_F iA. Surface burner IocatorB. Left rear control knobC. Right rear control knobCooktopD. Left front control knobE. Right front control knobA B CCOOKTOP USECoo{ks© Con$ s sFire HazardDo not let the burner flame extend beyond the edge ofthe pan.Turn off all controls when not cooking.Failure to follow these instructions can result in deathor fire.IMPORTANT: Your cooktop is factory-set for use with Naturalgas. If you wish to use LP gas, an LP Gas Conversion Kit isincluded with your new cooktop. See the instructions includedwith the LP Gas Conversion Kit for details on making thisconversion.Electric igniters automatically light the surface burners whencontrol knobs are turned to LITE.The large burners (12,000 Btu/h [British Thermal Units]) providethe highest heat setting, and are ideal for cooking large quantitiesof food or liquid, using large pots and pans. The small burners(9,100 Btu/h and 6,000 Btu/h) allow more accurate simmercontrol at the lowest setting, and are ideal for cooking smallerquantities of food, using smaller pots and pans.Before setting a control knob, place filled cookware on the grate.Do not operate a burner while using empty cookware or withoutany cookware on the grate.NOTE: Visually check that the burner has lit. If the burner doesnot ignite, listen for a clicking sound. If you do not hear the igniterclick, turn the burner off. Check for a tripped circuit breaker orblown household fuse.Check that the control knob is pressed completely down on thevalve shaft. If the spark igniter still does not operate, call a trainedrepair specialist.Proper grounding and polarity are necessary for correct operationof the electric ignition system. If the wall receptacle does notprovide correct polarity, the igniter will become grounded andoccasionally click, even after the burner has ignited. Contact atrained repair specialist to check the wall receptacle to seewhether it is wired with the correct polarity.A. Model and serial number plate(located under cooktop)B. Surface burner grateDC. Surface burner capD. Control panel