IKEA LAGAN HGC3K User Manual

Also see for FRAMTID: Installation manual Manual User guide Manual User manual

Contents

IKEA LAGAN HGC3K User Manual Manual pdf 8 page image

InstallationManufacturer is not responsible for any injuryto persons and pets or damage to propertycaused by failure to comply following require-ments.Caution! To proceed with the installationrefer to the assembly instructions.Warning! Installation process must followthe laws, ordinances, directives andstandards (electrical safety rules andregulations, proper recycling in accordancewith the regulations, etc.) in force in the countryof use!Warning! The appliance must beearthed!Warning! Risk of injury from electricalcurrent.• The electrical mains terminal is live.• Make electrical mains terminal free of volt-age.• Loose and inappropriate plug and socketconnections can make the terminal over-heat.• Have the clamping connections correctly in-stalled.• Use strain relief clamp on cable.• Follow the connection diagram (it is locatedon the underneath surface of the casting ofthe hob).Important! You must observe the minimumdistances to other appliances and furniturecabinets or other units according to AssemblyInstruction.If there is no oven beneath the hob insert a di-viding panel at a minimum distance of 20 mmfrom the bottom of the hob.Do not use silicon sealant between the appli-ance and the worktop. Avoid installing the ap-pliance next to doors and under windows ashot cookware may be knocked off the ringswhen doors and windows are opened.Only an authorized service engineer can in-stall, connect or repair this appliance. Use onlyoriginal spare parts.Electrical connectionBefore connecting, check that the nominal volt-age of the appliance stated on the ratingplate, corresponds to the available supplyvoltage. Also, check the power rating of theappliance and ensure that the wire is suitablysized to suit the appliance power rating (referto the Technical data chapter).The rating plate is located on the lower casingof the hob.The appliance is not provided with mains ca-ble. Buy the right one from specialized dealer.Single-phase or two-phase connection re-quires the mains cable of type H05 BB-F/H05V2V2-F Tmax 90°C (equal or higher).The appliance works perfectly on AC 230 V,AC220V~ or AC240V~ 50Hz electrical net-work.You must have the means for disconnection in-corporated in the fixed wiring. Have the ap-pliance connected to the mains using a devicethat allows the appliance to be disconnectedfrom the mains at all poles with a contact open-ing width of at least 3 mm, eg. automatic lineprotecting cut-out, earth leakage trips or fuse.You must have the connection and the con-necting links carried out as shown in the con-nection diagram (it is located on the under-neath surface of the casting of the hob).ENGLISH 8